Pines Engineering & H&H Toolin

Manual Model-2

Manual Model-2

The Pines Model 2 is built to stock with the following standard equipment:

• Counter clockwise rotation
• 1xD bend capability
• Standard pressure die holder and master bar
• Clamp die holder
• Mandrel extractor
• 7-inch color touch screen Dial-A-Bend® DAB 7 Control
• Independent clamp and pressure die close
• Standard wiper die holder

Many options are available to customize the machine. Including but not limited to:

• In-line pressure die assist
• Electric control options (Swing and Stationary Arm)
• Mandrel lubricator
• Base extensions for increased tube over mandrel length
• Overhead tie bars
• Laser scanner or safety mat to guard the swing arm area
• Clockwise rotation
• Long arms

Capacities 

•    Round tubing, mild steel Y.P. to 40,000 psi – 3” x .109
•    Round Tubing, non-ferrous Y.P. to 25,000 psi – 3” x .187
•    Round tubing, Stainless steel Y.P. to 60,000 psi – 3” x .065
•    Steel pipe, 2 IPS schedule 80
•    Square tubing, mild steel – 2” x .125 

Specifications

• Maximum standard radius – 12”
• Minimum radius to diameter ratio – 1
• Maximum bend angle – 190º
• Bend arm repeatability – +/- .1º
• Maximum standard tube length over mandrel – 89”
• Bend arm speed – 6 RPM avg. (180°)
• Motor horsepower – 15HP
• Approximate weight – 4,600 lbs.

Safety Features

• Safety plates protecting both bend and return sides of swing arm
• All electrical components in power panel are “finger-safe” and are in accordance with NFPA standards
• Machine is labeled with pinch and hazard points