Pneumatic Module MPM500 for the Meca500
Pneumatic Module MPM500 for the Meca500
Control various pneumatic end-of-arm-tooling components directly from the Meca500 using our pneumatic module.
Mecademic’s pneumatic module MPM500 is designed specifically for the Meca500 (R3) and allows you to interface the robot with various pneumatic tools. The module consists of two 3-way 2-position normally closed solenoid valves. The valves share the same pressure port (IN) and exhaust port (OUT) but can be independently controlled directly from the robot.
What are the benefits of using Mecademic’s pneumatic module?
Fully integrated
Our pneumatic module is custom-built for and fully-integrated with our Meca500 robot arm (R3). As such, its two valves can be controlled directly within the stream of commands used to control the robot.
Extremely compact
Encapsulating two miniature solenoid valves in an optimized, streamlined aluminum body, the MPM500 is ultra-light, yet sturdy and offers versatility in EOAT.
Plug and work design
With just a clamp to tighten, a cable connector to screw, and a few pneumatic tubes to plug, you can be ready to operate your pneumatic end-of-arm-tooling in just minutes.
Requiring single tubing
With the MPM500, you need to attach a single pneumatic tube along the robot arm, reducing the risk for entanglements.
Specifications
Operating pressure7 bar (105 PSI)Flow rate29.74 LPM (1.05 CFM)
Response timeON 8 ms, OFF 10 ms
PortsFour M5 threaded orifices, with barb fittings for 1/16 inch ID tube preinstalled on ports 1, 2, and IN, and a pneumatic muffler on port OUT
