J. D. Gould Company, Inc.

M13EP Solenoid Valve

General Specifications

• Low Pressure STEAM Valves
• Internal Piston–Pilot Operated
• 2–Way
• Full Ported
• Packless
• Bronze Body
• Normally Closed (Energize to Open)
• UL listed
• Ethylene Propylene (EPDM) Leakproof seat provides Positive Shutoff

SERVICE RATINGS

• Pipe Sizes Available: 1/8”, 1/4”, 3/8”, 1/2”, 3/4”, 1”, 1¼”, 1½”, 2” NPT (Must Specify)
• Media: STEAM, Hot Water, Hot Air
• Pressure Range: 5 – 50 psi

A minimum pressure drop of 5 psi (ΔP) is needed for proper operation.For optimal valve operation, specify your actual pressure range.

For more details Consult our Valve Specialists @ 800.634.6853

• Rated Fluid Temperature Range: –40°F to +298°F
• Voltages Available: 24, 120, 240, 480 or Dual Voltage: 120–240 VAC 50–60Hz 26 Watts Max
• Coil Specifications:
• NEMA 4X Waterproof Corrosion Resistant Coil
• Continuous Duty Polyester, Thermoset Epoxy Molded with 18” Leads and ½” Conduit Connector
• Insulation: Class H (298°F Maximum Fluid Temp @ 77°F Ambient)

Valve Construction

• BODIES are Sand Cast Bronze – Rated: WSP 200 psi – WOG 400 psi.
• BONNET ASSEMBLIES are 304 SS Tubes with Brass Tube Plugs Silver–soldered to a Brass Bonnet. BONNET O–RING is EPDM.
• PISTON ASSEMBLIES are Brass with Brass SEAT SCREWS with an EPDM Insert, and 316SS EXPANDER RINGS behind Glass & Moly–Filled Teflon®
• PISTON RINGS plus an EPDM SEAT DISC and Brass or Bronze GUIDE NUT.
• PILOT VALVE is 416SS and PISTON SPRING is 302SS.

MOUNTING & SERVICE

• Installation: Valves must be mounted in horizontal pipe with coil vertical, upright and on top. A 40–mesh inline strainer is recommended ahead of the valve.
• Maintenance: As with any piece of equipment, reasonable inspection and maintenance of components should be periodically performed. Frequently check operation, cleanliness and internal wear. Any questions, consult factory.

NOTE: Gould Solenoid Valves are designed for Industrial–Commercial applications. Residential/Consumer applications will void the warranty. Questions ~ Call our Experts.